Possible upgrades events

[wilkxt]

Thank you for your advice, I'll see you all ..

I have another question, do you manually turn ON/OFF virtual outputs (EVNT1-EVNT8) ??

No, only by event

[kollnjak]

Hi,

1) I have encountered an error in the event, see picture (DS4=72°C, but DS4 same condition, other behavior LK3) ..
The separate condition works correctly, but with DIFF is not correct

  chyba teploty.jpg (Rozmiar: 65.44 KB / Pobrań: 1,859)

2) would the ON / OFF outputs of the event page be displayed (GREEN/RED)?
3) would you see virtual outputs ON / OFF on page control / output?

[wilkxt]

I will check this in next week

[kollnjak]

Hello,

Is this train still alive? Has it ever been resolved?

Thank you in advance for your good work

[wilkxt]

check this soft http://tinycontrol.pl/forum/download/file.php?id=550

[kollnjak]

Hi,

Upgraded firmware on 1_39b1, but i do not see changes .. viz obrazek


  LK3-mistake.jpg (Rozmiar: 170 KB / Pobrań: 1,824)

1) bad condition prediction, see blue circle image (top blue circle is right with output OUT3)

2) will display output status (yellow circle) ON / OFF - Green / Red

3) DIFF1,2 and ENT1-EVNT8 - virtual outputs do not manually switch on/off or display ("status page", "control/out page")

Thx your job

Kollnjak

[wilkxt]

what is value diff1 and DS4?

[kollnjak]

I think there is a problem in temperatures in the second part of the condition, see the next picture


  LK3-mistake2.jpg (Rozmiar: 132 KB / Pobrań: 1,809)

The first(top) oranges circle is the correct (DS3=25°C, OUT1=OFF)