03-28-2023, 03:44 PM
(Ten post był ostatnio modyfikowany: 03-28-2023, 04:14 PM przez SDA.
Powód edycji: Figured it out
)
Thank you very much, yes working now.
As to the reason for wanted to upgrade from Ver. 6.01 was when I power-cycle the interface, I loose previous settings, and outputs are in the OFF status.
Upgrading to V6.02, the problem remains.
Eg - Set outputs all ON and after power-cycle all is OFF.
Thank you
Never mind,
From the Events config sub menu, if the ON delay is set to ON, output settings are stored.
As to the reason for wanted to upgrade from Ver. 6.01 was when I power-cycle the interface, I loose previous settings, and outputs are in the OFF status.
Upgrading to V6.02, the problem remains.
Eg - Set outputs all ON and after power-cycle all is OFF.
Thank you
Never mind,
From the Events config sub menu, if the ON delay is set to ON, output settings are stored.