08-14-2017, 09:13 PM
Hi,
I have a fitmware 1.41b
I have set events (see picture) and can not manually turn ON OUT3 ..
planovac 8.8.2017.jpg (Rozmiar: 165.18 KB / Pobrań: 1,347)
Condition - DS4 and DIff1 always shuts off my output (if no conditions are OK)
Is it good behavior? In the previous firmware, I would manually turn OUT ON
Or outputs are manually switched on only for the completed events?
THX for your asnwer and good job
Kollnjak
I have a fitmware 1.41b
I have set events (see picture) and can not manually turn ON OUT3 ..
planovac 8.8.2017.jpg (Rozmiar: 165.18 KB / Pobrań: 1,347)
Condition - DS4 and DIff1 always shuts off my output (if no conditions are OK)
Is it good behavior? In the previous firmware, I would manually turn OUT ON
Or outputs are manually switched on only for the completed events?
THX for your asnwer and good job
Kollnjak
<t></t>