09-20-2012, 08:12 PM
Hi,
I have 3 pcs of the LanKontroler (I use 3.0 and 2.24 fw) as a first I would like apreciate this very powerfull HW and FW. So now my questions I have tried to connect to the device DS18B20 sensors but if I connect more than 3 sensors device rejects to start, if I disconnect third sensor (any) LanKontroler starts normaly. I tested on all devices with different fw versions and behavior is same or similar. So now I can use only two DS18B20 sensors.
Second question is about future support other Dallas one wire sensors (counters etc.) Is there any plan for next release of FW ?
Thanks and Best Regards
Jan Kyncl
Prague
I have 3 pcs of the LanKontroler (I use 3.0 and 2.24 fw) as a first I would like apreciate this very powerfull HW and FW. So now my questions I have tried to connect to the device DS18B20 sensors but if I connect more than 3 sensors device rejects to start, if I disconnect third sensor (any) LanKontroler starts normaly. I tested on all devices with different fw versions and behavior is same or similar. So now I can use only two DS18B20 sensors.
Second question is about future support other Dallas one wire sensors (counters etc.) Is there any plan for next release of FW ?
Thanks and Best Regards
Jan Kyncl
Prague
<t></t>