Q/A ENG update / firmware

[wilkxt]

Hi,
I have 3 pcs of the LanKontroler (I use 3.0 and 2.24 fw) as a first I would like apreciate this very powerfull HW and FW. So now my questions I have tried to connect to the device DS18B20 sensors but if I connect more than 3 sensors device rejects to start, if I disconnect third sensor (any) LanKontroler starts normaly. I tested on all devices with different fw versions and behavior is same or similar. So now I can use only two DS18B20 sensors.
Prague

We must check it

Hi,
Second question is about future support other Dallas one wire sensors (counters etc.) Is there any plan for next release of FW ?
Prague

Yes, we plan this in 3.xx series firmware