02-10-2017, 02:01 PM
I have problem with INPD1-3 on controller V2 firmware 2.15.
On the INPD4 is now the consumption meter and it works perfectly. I'm reading the value of kWh from CACTI by SNMP.
On another input (INPD1-3) is now connect another pulse unit and If I sand the pulse on INPD1,2 or 3 than the SNMP is ca. 5 min off .
Same problem is when is shortly the jumper bet between GND and INPD1 …3.
I will read the address from INMP3 in to CACTI and in CACTI is my second counter.
Can somebody help me with my problem?
On the INPD4 is now the consumption meter and it works perfectly. I'm reading the value of kWh from CACTI by SNMP.
On another input (INPD1-3) is now connect another pulse unit and If I sand the pulse on INPD1,2 or 3 than the SNMP is ca. 5 min off .
Same problem is when is shortly the jumper bet between GND and INPD1 …3.
I will read the address from INMP3 in to CACTI and in CACTI is my second counter.
Can somebody help me with my problem?