Forum Tiny Control Solution
DS18B20 wiring for RJ12 / max cable lenght of AM2320 - Wersja do druku

+- Forum Tiny Control Solution (https://forum.tinycontrol.pl)
+-- Dział: LanKontroler - sprzęt i wersje wsadów, problemy, zastosowanie (https://forum.tinycontrol.pl/forumdisplay.php?fid=3)
+--- Dział: LanKontroler V3.5 (https://forum.tinycontrol.pl/forumdisplay.php?fid=28)
+--- Wątek: DS18B20 wiring for RJ12 / max cable lenght of AM2320 (/showthread.php?tid=1428)

DS18B20 wiring for RJ12 / max cable lenght of AM2320 - atosz - 05-25-2020

Hello,

I have several question regarding sensors and sensor connections.

  1. I would like to connect some DS18B20 to my LanController v3.6 via RJ12 splitter.
    What is the sequence for RJ12?

  2. A question for RJ12 splitter:
    - is it possible to connect more than one AM2320 to LanController via RJ12 splitter?


  3. At the moment i am using one AM2320 but i always need to press "I2C sensor detection" (Inputs menu) for displaying the values, after a few mins or sometime a few hours it does not show automatically any more. Is it possible that the sensor is too far from the LanController? The cable lenght is around 8-10m.

  4. There is a menu called "I2C and 1Wire Sensors". Is there any manual how to use this section?

Thank you!

RE: DS18B20 wiring for RJ12 / max cable lenght of AM2320 - wilkxt - 07-17-2020

(05-25-2020, 10:56 AM)atosz napisał(a): [*]I would like to connect some DS18B20 to my LanController v3.6 via RJ12 splitter.
What is the sequence for RJ12?

https://tinycontrol.pl/wp-content/uploads/2019/03/LAN-Controller-v35-short-manual_200x210_mm-1.pdf


(05-25-2020, 10:56 AM)atosz napisał(a): [*]A question for RJ12 splitter:
- is it possible to connect more than one AM2320 to LanController via RJ12 splitter?


Now, only one

(05-25-2020, 10:56 AM)atosz napisał(a): [*]At the moment i am using one AM2320 but i always need to press "I2C sensor detection" (Inputs menu) for displaying the values, after a few mins or sometime a few hours it does not show automatically any more. Is it possible that the sensor is too far from the LanController? The cable lenght is around 8-10m.

[*]There is a menu called "I2C and 1Wire Sensors". Is there any manual how to use this section?
[/list]

https://tinycontrol-software.gitlab.io/lk3docs/en/pages/i2c-1wire-sensors/