+- Forum Tiny Control Solution (https://forum.tinycontrol.pl)
+-- Dział: LanKontroler - sprzęt i wersje wsadów, problemy, zastosowanie (https://forum.tinycontrol.pl/forumdisplay.php?fid=3)
+--- Dział: LanKontroler - wersje oprogramowania (https://forum.tinycontrol.pl/forumdisplay.php?fid=4)
+---- Dział: Przykłady zastosowań przez użytkowników. (https://forum.tinycontrol.pl/forumdisplay.php?fid=6)
+---- Wątek: RELAY AFTER START-doesnt working (/showthread.php?tid=480)
Re: RELAY AFTER START-doesnt working - dudo02 - 01-04-2015
wilkxt napisał(a):for versions 1.2 probably will also beHi ,Tomek.
I tried upgrade new firmware 3.10 .
Upgrade was successfull ,but LK doesnt working :| .
Looks like dead - RJ 45 conector LED`s doesnt blinkinkg at all.
Reset button do nothing.
Is there possibility put back old firmware in this condition?
Re: RELAY AFTER START-doesnt working - wilkxt - 01-04-2015
do you have LK1.2 od 2.0?
Re: RELAY AFTER START-doesnt working - dudo02 - 01-04-2015
I got 1.2
Re: RELAY AFTER START-doesnt working - wilkxt - 01-07-2015
what soft version you upgrade? Show link to file.
Re: RELAY AFTER START-doesnt working - dudo02 - 01-08-2015
Upgrade from -see attach
New file which I used for upgrade -http://tinycontrol.ats.pl/media/katalog/kontrolery/lan-kontroler/files/lan2-module-ver-3-10.bin
Re: RELAY AFTER START-doesnt working - wilkxt - 01-09-2015
you use firmware to LK2, this is bad. I have to look at one way, and as work, I write the solution
Re: RELAY AFTER START-doesnt working - dudo02 - 01-10-2015
Sorry ,I dont understand.
What was wrong-that I used firmware LK2 for hardware LK1.2?
Re: RELAY AFTER START-doesnt working - wilkxt - 01-11-2015
firmware LK2 is to hardwere 2.0 not 1.2
Re: RELAY AFTER START-doesnt working - dudo02 - 01-22-2015
Ok its clear.
But was probably missunderstanding ,because in previous page I asked to you if new software(mean 3.1) is apllicable for hardware 1.2.And you answer was"probably yes"...
Anyway-doesnt matter...
Any idea how to fix my LK?
Where is firmware located-in EPROM?
If yes ,what about changing EPROM?
I would like to fix my LK because is managing my HEAT SYTEM in house ,and now its bit complicated...
Re: RELAY AFTER START-doesnt working - wilkxt - 01-22-2015
soft is in microkontroler not eeprom, but problem that LK not run is eeprom.
In LK1.2 eeprom has adres 0, but in LK2.0 eeprom has adres 2.
In LK1.2 pin2 in eeprom is connected to GND, unconnect them and connect pin2 to VCC (3,6V), now tray run LK, if run (propably on last IP or default IP 192.168.1.100) upgrade to lk1,2 soft version and connect pin2 to gnd.