hello
is possible to have firmware with option in shedul time switch relay 0-4 to time depend on state INP1D,INP2D?
example:
every day between 14:00-20:00 if INP1D=1 every 20 minutes set OUT1 to 1 for 2 sec
thanks for reply
with best regard Peter
We can quickly add options OUT 0-4 switching at fixed time intervals when INP1D is active but not at specific times, it is more complicated. Is it required it to be at certain times?
Do you use a watchdog?
we don´t use wotchdog, and currently we can use request function only after working time whitch is varian .
sweet napisał(a):hello
is possible to have firmware with option in shedul time switch relay 0-4 to time depend on state INP1D,INP2D?
example:
every day between 14:00-20:00 if INP1D=1 every 20 minutes set OUT1 to 1 for 2 sec
thanks for reply
with best regard Peter
We add this functionality, upfrade soft to 2.29 (
http://tinycontrol.ats.pl/forum/viewtopic.php?f=2&t=510) version and test
For your example you must set:
[
attachment=33]
[
attachment=34]
hello, we have problem with this firmware,
1) after reset controller out1 switch on and stay in this position
2) controller send two impulz, second impulz is random
i attach settings off shedull
[
attachment=46]
thanks for reply
sweet napisał(a):hello, we have problem with this firmware,
1) after reset controller out1 switch on and stay in this position
thanks for reply
1.What you set in "Auto Switch Out" on Control Panel?
2.Do you use some Input from "Config events"?
hello
I test Auto switch Out checked and unchecked and this option nothing doing with auto on rele to permanent switch to 1 after reset.
I use event INP1D to send mail id board switch REL.