Forum Tiny Control Solution

Pełna wersja: DS18B20 wiring for RJ12 / max cable lenght of AM2320
Aktualnie przeglądasz uproszczoną wersję forum. Kliknij tutaj, by zobaczyć wersję z pełnym formatowaniem.
Hello,

I have several question regarding sensors and sensor connections.

  1. I would like to connect some DS18B20 to my LanController v3.6 via RJ12 splitter.
    What is the sequence for RJ12?

  2. A question for RJ12 splitter:
    - is it possible to connect more than one AM2320 to LanController via RJ12 splitter?


  3. At the moment i am using one AM2320 but i always need to press "I2C sensor detection" (Inputs menu) for displaying the values, after a few mins or sometime a few hours it does not show automatically any more. Is it possible that the sensor is too far from the LanController? The cable lenght is around 8-10m.

  4. There is a menu called "I2C and 1Wire Sensors". Is there any manual how to use this section?

Thank you!
(05-25-2020, 10:56 AM)atosz napisał(a): [ -> ][*]I would like to connect some DS18B20 to my LanController v3.6 via RJ12 splitter.
What is the sequence for RJ12?

https://tinycontrol.pl/wp-content/upload...0_mm-1.pdf


(05-25-2020, 10:56 AM)atosz napisał(a): [ -> ][*]A question for RJ12 splitter:
- is it possible to connect more than one AM2320 to LanController via RJ12 splitter?


Now, only one

(05-25-2020, 10:56 AM)atosz napisał(a): [ -> ][*]At the moment i am using one AM2320 but i always need to press "I2C sensor detection" (Inputs menu) for displaying the values, after a few mins or sometime a few hours it does not show automatically any more. Is it possible that the sensor is too far from the LanController? The cable lenght is around 8-10m.

[*]There is a menu called "I2C and 1Wire Sensors". Is there any manual how to use this section?
[/list]

https://tinycontrol-software.gitlab.io/l...e-sensors/